636
Appendix B
Configuring the Catalyst 1900 Switch
6.
Write the command to remove the permanent address you just added
to port e0/1.
7.
Write the command to view the statistics of port e0/5.
8.
Write the commands to create three VLANs: Purchasing, Sales, and MIS.
9.
Write the command to assign ports 2 and 3 to Sales, 4 and 5 to
Purchasing, and 6 and 7 to MIS. Use only static assignments.
10.
Write the command to make your switch a VTP client.
11.
Write the command to set your switch to be a transparent switch.
12.
Write the command that will show the VTP status of your switch.
13.
Write the command that will put interface B into auto-trunk mode.
14.
Write the command to view all VLAN information on a switch.
15.
Write the command to set interface 5 to VLAN 2.
(The answers to the Written Lab can be found following the answers to
the Review Questions for this chapter.)
Hands-on Labs
T
here are seven hands-on labs in this section. You need to have access
to a 1900 switch or routing simulator.
Lab B.1: Managing the 1900 Switch
Lab B.2: 1900 Switch Operations
Lab B.3: Creating VLANs
Lab B.4: Assigning VLANs to Switch Ports
Lab B.5: Configuring Trunking
Lab B.6: Configuring VTP
Lab B.7: Configuring Inter-VLAN Routing with ISL
Copyright ©2002 SYBEX, Inc., Alameda, CA
www.sybex.com