Written Lab 10
549
Written Lab 10
1.
Write the command to see the encapsulation method on serial 0 of a
Cisco router.
2.
Write the commands to configure s0 to PPP encapsulation.
3.
Write the commands to configure a username of todd and password of
cisco that is used on a Cisco router.
4.
Write the commands to enable CHAP authentication on a Cisco BRI
interface.
5.
Write the commands to configure the DLCI numbers for two serial
interfaces, 0 and 1. Use 16 for s0 and 17 for s1.
6.
Write the commands to configure a remote office using a point-to-
point subinterface. Use DLCI 16 and IP address 172.16.60.1/24.
The IPX network is 16.
7.
Write the commands to set the switch type of basic-ni on a Cisco
router BRI interface.
8.
Set the switch type on a Cisco router at the interface level.
9.
Write the command that will specify interesting traffic to bring up the
ISDN link. Choose all IP traffic.
10.
Write the commands necessary to apply the command that you spec-
ified in Question 9 to a Cisco router.
11.
Write the commands to configure the dialer information on a Cisco
router.
12.
Write the commands to set the dialer load-threshold and the idle-time
percentage.
13.
Write the commands that will set the queue for packets at 75 when
they are found interesting and need a place to wait for the ISDN link
to come up.
14.
Write out the five steps in the configuration of the dialer information.
15.
Write out the five steps that give a basic description of how DDR
works when an interesting packet is received in a router interface.
(The answers to Written Lab 10 can be found following the answers to the
Review Questions for this chapter.)
Copyright ©2002 SYBEX, Inc., Alameda, CA
www.sybex.com