440
Chapter 8
Configuring Novell IPX
Incoming access list is not set
Outgoing access list is not set
IPX helper access list is not set
SAP GNS processing enabled, delay 0 ms, output filter
list is not set
SAP Input filter list is not set
SAP Output filter list is not set
SAP Router filter list is not set
Input filter list is not set
Output filter list is not set
Router filter list is not set
Netbios Input host access list is not set
Netbios Input bytes access list is not set
Netbios Output host access list is not set
Netbios Output bytes access list is not set
Updates each 60 seconds, aging multiples RIP: 3 SAP: 3
SAP interpacket delay is 55 ms, maximum size is 480
bytes
RIP interpacket delay is 55 ms, maximum size is 432
bytes
--More--
This command shows you the RIP and SAP information received on a cer-
tain interface. The show ipx traffic command shows the RIP and SAP
information received on the router in whole.
The Show Protocols Command
There is one more command that shows the IPX address and encapsula-
tion type of an interface: the show protocols command. This command
shows the routed protocols configured on your router and the interface
addresses.
Here is the show protocol command run on the 2501A router:
2501A#sh protocols
Global values:
Internet Protocol routing is enabled
IPX routing is enabled
Ethernet0 is up, line protocol is up
Copyright ©2002 SYBEX, Inc., Alameda, CA
www.sybex.com