Page 484

Monitoring IPX on Cisco Routers

439

RIP: 1 RIP requests, 0 RIP replies, 6 routes

8 RIP advertisements received, 230 sent

12 RIP flash updates sent, 0 RIP format errors

Echo: Rcvd 0 requests, 5 replies

Sent 5 requests, 0 replies

0 unknown: 0 no socket, 0 filtered, 0 no helper

0 SAPs throttled, freed NDB len 0

Watchdog:

0 packets received, 0 replies spoofed

Queue lengths:

IPX input: 0, SAP 0, RIP 0, GNS 0

SAP throttling length: 0/(no limit), 0 nets

pending lost route reply

--More--

Remember that the show ipx traffic command shows you the statistics

for IPX RIP and SAP information received on the router. If you wanted to
view the statistics of RIP and SAP information received only on a specific
interface, use the next command we discuss: show ipx interface.

The Show IPX Interface Command

The show ipx interface command gives you the interface status of IPX
and the IPX parameters configured on each interface.

The show ipx interface e0 command shows you the IPX address and

encapsulation type of the interface. If you use the show interface e0 com-
mand, remember that it does not provide the IPX address of the interface,
only the IP address.

Notice the IPX address is 10.0000.0c8d.5c9d and the frame type is

Novell-Ether (802.3).

2501A#sh ipx int e0

Ethernet0 is up, line protocol is up

IPX address is 10.0000.0c8d.5c9d, NOVELL-ETHER [up]

Delay of this IPX network, in ticks is 1 throughput 0

link delay 0

IPXWAN processing not enabled on this interface.

IPX SAP update interval is 1 minute(s)

IPX type 20 propagation packet forwarding is disabled

www.sybex.com