Page 473

428

Chapter 8

Configuring Novell IPX

2501A

The 2501A router knows only about IPX networks 10 and 20 since that is
what is directly connected. IPX RIP will tell router 2501A about networks
30, 40, and 50. Here is the routing table from the 2501A router:

2501A#sh ipx route

[output cut]

5 Total IPX routes. Up to 1 parallel paths and 16 hops

allowed.

No default route known.

C 20 (HDLC), Se0

C 10 (NOVELL-ETHER), Et0

R 30 [13/02] via 20.0000.0c8d.2b8c, 16s, Se0

R 40 [07/02] via 20.0000.0c8d.2b8c, 17s, Se0

R 50 [07/03] via 20.0000.0c8d.2b8c, 17s, Se0

2501A#

In the routing table above, notice the two directly connected networks

and the three RIP-found networks. The IPX address of the neighbor's inter-
face is included in the routing table as well as the interface the router will use
to get to the remote network.

2501B

The routes found from IPX RIP in the 2501B router are 10 and 20. Here is
the output from the 2501B router:

2501B#sh ipx route

[output cut]

5 Total IPX routes. Up to 1 parallel paths and 16 hops

allowed.

No default route known.

C 20 (HDLC), Se0

C 40 (HDLC), Se1

C 30 (NOVELL-ETHER), Et0

R 10 [07/01] via 20.0000.0c8d.3d8e, 16s, Se0

R 50 [07/01] via 40.0000.0c8d.5c9d, 17s, Se1

2501B#

www.sybex.com