Page 45

lxii

Answers to Assessment Test

52.

B. The Cisco command Novell-ether is the encapsulation for 802.3.
However, this is the default on Ethernet links if no encapsulation is
specified. See Chapter 8 for more information.

53.

C. IGRP, as well as EIGRP. Use bandwidth and delay of the line, by
default, when making routing decisions. See Chapter 5 for more infor-
mation.

54.

E. IPX SAP filters use the access list numbers 10001099. See
Chapter 9 for more information.

55.

B. The old command to copy a file from a TFTP host to DRAM is
config

net. See Chapter 7 for more information.

56.

D. The global command router rip will turn RIP routing on in the
router. You then need to tell the RIP routing protocol which network
to advertise. See Chapter 5 for more information.

57.

B. IPX standard access lists use the numbers 800899. See Chapter 9
for more information.

58.

C, D. The commands show running-config and show frame pvc
will show you the configured PVC for each interface or subinterface.
See Chapter 10 for more information.

59.

C. Each vendor uses HDLC by default on the serial links. They
are both proprietary. To communicate between vendors, you must
use something like PPP or Frame Relay. See Chapter 10 for more
information.

60.

B. Full-duplex Ethernet creates a point-to-point connection between
the transmitter circuitry of the transmitting station and the receiving
circuitry of the receiving station. See Chapter 1 for more information.

61.

C. Even though newer technologies are probably a better choice at
this point for hometocorporate office connections, Cisco's answer
to this question is ISDN because of the period connection that is
needed. See Chapter 10 for more information.

62.

B. The

show

ipx servers command shows from which NetWare

servers the routers have received SAP packets. See Chapter 8 for more
information.

www.sybex.com