314
Chapter 5
IP Routing
22.
IGRP uses which of the following as default parameters for finding the
best path to a remote network? Select all that apply.
A.
Hop count
B.
MTU
C.
Cumulative interface delay
D.
STP
E.
Path bandwidth value
23.
If you have a routing table listing both I's, S's, and R's on the left side
of the table, what does this mean?
A.
That your table needs to be flushed
B.
That static, RIP, and OSPF routes are in the routing table
C.
That static, RIP, and IGRP routes are in the routing table
D.
That a Reliable port was used to find Serial WAN information by
using an Internal routing protocol
24.
If your routing table has a static, a RIP, and an IGRP route to the same
network, which route will be used to route packets?
A.
Any available route
B.
RIP route
C.
Static route
D.
IGRP route
E.
They will all load-balance
25.
You have the following IGRP configuration:
Corporate(config)#router igrp 10
Corporate(config-router)#network 172.16.10.0
Corporate(config-router)#network 172.16.20.0
Corporate(config-router)#network 172.16.30.0
Corporate(config-router)#network 10.0.0.0
Copyright ©2002 SYBEX, Inc., Alameda, CA
www.sybex.com