background image
Foundation Summary 595
Table 8-37 summarizes the more popular commands used for ISDN configuration and
verification.
frame-relay interface-dlci
dlci [ietf | cisco]
Interface
Defines a DLCI used for a VC to another DTE.
frame-relay payload-
compress
{packet-by-
packet
| frf9 stac}
Interface
subcommand
Defines payload compression on point-to-point
subinterfaces.
Table 8-37
ISDN Configuration Commands
Command
Configuration
Mode
Purpose
isdn switch-type switch-type
Global or interface
Defines to the router the type of ISDN
switch to which the ISDN line is
connected at the central office.
isdn spid1 spid
Interface
Defines the first SPID.
isdn spid2 spid
Interface
Defines the second SPID.
isdn caller number
Interface
Defines a valid number for incoming
calls when using call screening.
isdn answer1 [called-party-
number
][:subaddress]
Interface
Specifies the ISDN number or
subaddress that must be used on
incoming calls for this router to
answer.
isdn answer2 [called-party-
number
][:subaddress]
Interface
Specifies a second ISDN number or
subaddress that must be used on
incoming calls for this router to
answer.
dialer-list [list nnn] protocol
[protocol-type] permit | deny
Global
Defines types of traffic considered
interesting.
dialer-group n
Interface
Enables a dialer list on this interface.
dialer in-band
Interface
Enables dial out and dial in on this
interface. This command is used only
for serial lines that connect to a TA,
not for native ISDN interfaces that use
the out-of-band D channel.
dialer string string
Interface
Is a dial string used when dialing only
one site.
Table 8-36
Frame Relay Configuration Commands (Continued)
Command
Configuration
Mode
Purpose
continues
ch08.fm Page 595 Monday, March 20, 2000 5:17 PM