Jump to content United States-English
HP.com Home Products and Services Support and Drivers Solutions How to Buy
» Contact HP
More options
HP.com home
 HP Integrity Virtual Machines Version 4.0 Release Notes > Chapter 7 Networking Information

Restarting Vswitches
» 

Technical documentation

Complete book in PDF
» Feedback
Content starts here

 » Table of Contents

 » Index

spacerspacerspacer
spacer
spacer
  		 
 

It is necessary to restart the vswitch when:

  • You replace the physical network card associated with the vswitch.

  • You change a VM Host IP address associated with the vswitch's network interface card.

  • You change the network interface characteristics on the VM Host; for example, by using the lanadmin command to change checksum offloading (CKO).

  • You notice that there is no communication from an avio_lan interface to a lan interface after booting the guest(s) while the vswitch is down.

For information about how to restart vswitches, see the HP Integrity Virtual Machines Installation, Configuration, and Administration manual.

When you restart a vswitch, it is not necessary to restart the guests using the vswitch.



Do Not Turn on TSO on the VM Host and on HP-UX Guests
  		 


Guest AVIO Interface Behavior  
Printable version
Privacy statement Using this site means you accept its terms Feedback to webmaster
© 2008 Hewlett-Packard Development Company, L.P.