Jump to content United States-English
HP.com Home Products and Services Support and Drivers Solutions How to Buy
» Contact HP
More options
HP.com home
Ignite-UX Administration Guide: for HP-UX 11i > Chapter 11 Golden Images

Enabling the Client

» 

Technical documentation

Complete book in PDF
» Feedback
Content starts here

 » Table of Contents

 » Glossary

 » Index

Since the Ignite-UX server now knows about your new golden image, you can use Ignite-UX to install the golden image onto a client. To do this, you need to get the client to inform the Ignite-UX server that it is ready to install a new operating system. There are two methods for doing this.

Method 1:

If the system is currently running HP-UX 11i v1 or later versions — From the Ignite-UX server, use bootsys to reboot the client for which you want to install the new operating system. The client can be booted in a mode in which it can be controlled by the Ignite-UX user interface.

/opt/ignite/bin/bootsys -w -v client_name

This causes the client to boot a copy of the Ignite-UX kernel and file system that bootsys copies to the client. An icon representing the system appears in the Ignite-UX GUI on the Ignite-UX server when the client has completed the boot process, which can take several minutes.

NOTE: If the client had HP-UX 11i v2 (B.11.23) previously installed and you attempt to use the -R release option of bootsys to install HP-UX 11i v1 (B.11.11), you must use the -f option to override the previous installation. If you do not use the -f option, the installation will not continue and an error similar to the following appears:
ERROR: The target release "B.11.23" does not match the release "B.11.11" referenced by "previous config name" in "per client config file". Use the -f option to bootsys to cause removal of "per client config file" if you wish to install "B.11.23".

If the Ignite-UX server cannot resolve the client name, specify to bootsys the client_name and IP_address:

/opt/ignite/bin/bootsys -w -v client_name:IP_address

Method 2:

If the system does not have an operating system — Manually reboot the system. Interrupt the boot process and select the Ignite-UX server as the LAN boot source. This command is slightly different depending on your client.

For example, to install to a C8000 workstation, from the boot admin prompt, enter:

boot lan.10.2.72.150 install

You could use this command by replacing the IP address with the correct value for your Ignite-UX server. When prompted with a message about interacting with the initial system loader (ISL), enter n. for "No".

Printable version
Privacy statement Using this site means you accept its terms Feedback to webmaster
© Hewlett-Packard Development Company, L.P.