Appendix A nPartition Commands

Table of Contents

This appendix has details and command-line syntax for the HP nPartition Commands, including both the Original nPartition Commands and the Enhanced nPartition Commands.

The Original nPartition Commands were distributed as part of HP-UX 11i v1 (B.11.11) releases prior to the December 2004 release.
The Enhanced nPartition Commands are distributed with current HP-UX releases, including HP-UX 11i v3 (B.11.31), all releases of HP-UX 11i v2 (B.11.23), and releases of HP-UX 11i v1 (B.11.11) beginning with the December 2004 release.
The Enhanced nPartition Commands also are distributed as bundles on the HP Smart Setup CD for Windows, and as bundles on the HP Integrity Essentials Foundation Pack for Linux.

For an introduction to the nPartition Commands, see “Commands for Configuring nPartitions”. This appendix provides the following reference information for using HP nPartition Commands:

“parcreate Command”
“parmodify Command”
“parremove Command”
“parstatus Command”
“parunlock Command”
“fruled Command”
“frupower Command”
“cplxmodify Command” — Only supported by the Enhanced nPartition Commands.




	NOTE: For the most current information for these commands, refer to the online manpages: parcreate(1M), parmodify(1M), parremove(1M), parstatus(1), parunlock(1M), fruled(1M), frupower(1M), and cplxmodify(1M). On a Windows system, refer to StartProgramsHewlett-PackardnPar ManagementnPar Commands Manual.

Appendix A nPartition Commands

Technical documentation

» Table of Contents